Achieving the Most from Your Rechargeable Batteries
Success using your system revolves around three basic principles:
1. Using the right batteries for your wireless units.
2. Using the right charger for your batteries.
3. Understanding your run-time requirements.
If you've purchased Ansmann chargers and rechargeable batteries, you've already taken care of the first two.
You need to have a good handle on how long you will need to use the wireless unit. Depending on your set-up and run-time requirements, use these recommendations as a starting point:
9V Wireless Systems:
|Up to 5.5 hours, battery does not need to remain on charger||5030332||Ansmann 9V 250mah Max-E Plus||Up to 1000 recycles||No self-discharge, only 15% per year|
|Up to 5.5 hours, battery should remain on charger until ready for use||5035453||Ansmann 9V 250 mah||Up to 1000 recycles||About 4% per week|
|Up to 12 hours, battery should remain on charger until ready for use||RLI9600||HiTech 9V 600mah Lithium Ion||Up to 500 recycles||About 10% per week|
** When using HiTech 9V Lithium Ion Battery, these batteries can ONLY be charged on the HiTech Lithium Battery Charger. Any attempt to use a standard NiMH battery charger will result in explosion or leakage of cell.
AA Wireless Systems
|Up to 8 hours, batteries do not need to remain on charger||5035442||Ansmann AA 2500mah Max-E Plus||up to 1000 recycles||No self-discharge only 15% per year|
|Up to 12 hours, batteries need to remain on charger until ready for use||5030842||Ansmann AA 2700mah||up to 1000 recycles||About 4% per week|
|Up to 14 hours, batteries need to remain on the charger until ready for use||5035212||Ansmann AA 2850mah||up to 1000 recycles||About 4% per week|
The efficiency of the wireless unit and how hard you drive it, will determine actual run-time with high-capacity cells. For example, Shure ULX wireless units were tested with the Ansmann 250mah 9V cell and found to deliver 4 hours continuous use. (See Shure)
There has been much discussion regarding the differences in discharge curve between alkaline cells and NiMH rechargeable cells. Much of the concern is placed on the fact that with an alkaline battery there is a gradual decrease in voltage drop as opposed to a dramatic cut-off with the NiMH cells. A common mis-statement is "There is no warning signal with a rechargeable battery, so therefore a rechargeable cannot be trusted."
Simply not true.
In actuality, the reverse is true. A rechargeable battery's run-time is quite predictable. Once you determine the length of your run-time application, you can determine how much "spare time" you have with a rechargeable. With an alkaline, you're guessing or hoping the gradual voltage decrease still has enough juice to power the wireless. Or, if you're smart, you stop using the alkaline once it reaches a voltage of 8.8 or less on a 9V, or 2.1 V on a AA system.
Stretching the 1x use.
We've been trained to squeeze the most use of of each alkaline battery, but this is NOT the way to approach rechargeable usage. Because there is no memory effect with the Ansmann rechargeable, it does not matter if you use a 9V for 1 hour or 6 hours. When your church services are over, the use of the rechargeable is too. Do not try to use the same rechargeable for Sunday and then again on Wednesday, like you would normally try to acheive with an alkaine.
Charge the batteries in the appropriate charger to full charge. The charger will automatically switch to trickle charge and keep the batteries topped off.
Leave the batteries in the charger until ready to use, unless using Max E batteries. Max-E's can be stored charged in stand-by up to one year.
Just before use, check the remaining capacity in the battery utilizing the Energy Check
Load the batteries into the wireless units.
After use, remove batteries from wireless unit, and return to the charger until ready for the next use.
Spare Rechargeable Batteries
We recommend having several spare rechargeable batteries charged and ready to go. Some churches insist on having 2 sets of batteries for each wireless unit. As a minimum, we suggest at least 2-3 spares. If you are swapping batteries between services, then of course you should have two batteries per wireless.
What about Refresh -Reconditioning?
Ansmann rechargeable batteries are designed for high recycles -- up to 1000 times. To acheive the most recycles from your batteries, we highly recommend refreshing your cells. If you purchase an Energy Series charger - (Energy 8 or 16) the charger will automatically analyze each cell and perform refresh on it as needed. This becomes important as the battery ages -- particularly after 250-300 uses. Over time, the cell's chemistry can become imbalanced and crystal formation can occur. This will diminish run-time of the battery and additional recycles. Refreshing the cells periodically helps to restore chemistry to a balanced state. The refresh function is a proprietary algorithim of charge and discharge cycles at various voltage levels. Only Ansmann Energy Series chargers have this function. The Horizon 10-bay 9V does not. The 12-bay AA/9V charger has a manual discharge feature which will also increase battery life but not to the extent as refreshing. The Professional 8 and 16's do not have a refresh function, but they do have deep pulse charging cycles which help to optimize battery life as well.
Many churches, particularly those who utilize the 10-bay and 12-bay units also purchase an Energy Series charger and cycle the batteries through this charger about once every 1-2 months to increase their recycles. Over seven years, the cost of this additional charger is money well spent.
Still need help?
If you're still not sure about rechargeables, we can help. If you would like a FREE evaluation of your needs, click here. (At the end of the 3-minute movie, select Free Evaluation.)
For specific questions concerning your rechargeable system call us at 800-648-7239 We are available Monday thru Friday from 9AM to 5PM EST. If you'd rather email. send your questions to firstname.lastname@example.org